Boundary-ECT-RPM = eoit Boundary-ECT-RPM-Injection Pulsewidth = soit
Leave your ect table mostly stock since you have a stock cam, head setup - your running more boost, so dial back your colder temps some - otherwise you might wind up with cold throttle snap lean outs...
Keep the stock boundary of 520 up to 1000 rpms... End at 600ish around 46 to 5100 - your probably good to go to 610 or so to be honest... add 20 to the boundary by 2000 rpms (this is for the boost addition) / interpolate between these two remaining points and then smooth a couple of cells past that - should be good to go from that point... Redial in your MAF and VE tables - enjoy...