VCM scanner 2.25 no configuration & layouts

[Auto-Hentzschel]

Installed my 2.25 editor and scanner. But my folders for the scanner configurations and layouts are empty, no config file and no layout file. Where to get this?
Thanks!

[txcharlie]

If I understand your question, you were expecting preloaded config files and layouts? The only preloaded configs and layouts that I know of are your defaults when you open scanner. You can click the layout tab at the top of the page and see a few different defaults.

[Auto-Hentzschel]

Thanks for reply. Where to get preconfigured layouts?

[ElecTech]

Thanks for reply. Where to get preconfigured layouts?

You'll have to create your own.

[Higgs Boson]

If you buy a hammer, it doesn't come with the house.

Tip #1: Right Click

[8850]

Here's one I made up. Give it a try.

[Auto-Hentzschel]

over short or long I believe, I understand the system
But there seems to be some bugs in the parameters!
I work on a 2007 Mustang GT500. How it looks, the most important parameters are unusable.
1. can't find the MAF Voltage and also the O2B2S1 get no data. can anyone confirm that?

Thanks Henry

[cashbum]

Try 2.24?

[Z71]

Use 2.24. Way too many parameters incorrect or not usable for 2.25 yet.

[Auto-Hentzschel]

Now, where I worket some days with the VCM scanner, I can say, the thing seems to be verry unusable. the most parameters lie or are unshowable! I doublechecked with the Ford IDS. There are all parameters correct. but in the VCM scanner not. its the same if 2.24 or 2.25! like the VCM scanner is my O2 Sensor Bank2 broken and LTFT is not available or shows errors. but the Ford VCM show it correct.
How should I adjust the table correct?? Even I'm a starter!Attachment 54103Attachment 54105

[Keith@HPTuners]

Could be a bug in the definition for your vehicle.

Contact support so we can look into it.

[Auto-Hentzschel]

email was send to support.