-
Potential Tuner
cannot enable fuel trim
newbie here.
working on a '99 4.8l
I must have disabled my fuel trims inadvertently I cannot seem to enable my stft or ltft.
they are enabled in the editor and the calibration works but my fuel trims will not read and show up as disabled on my solus.
any ideas
Last edited by cambridgeratrod; 09-11-2015 at 12:33 PM.
-
Senior Tuner
Check any O2 sensor DTC enables (disables) which may
have been modified. Are there codes which don't produce
a SES light, but are inhibiting closed loop?
Check your ECT readings for reasonableness, and your
closed loop enable temperature. A messed up ECT can
cause you to never hit closed loop.
-
Potential Tuner
Thanks . I will check those monday
-
Potential Tuner
found the problem. missed a o2 ground when I remade the harness for my swap.