Car went into limp mode last night. I was accelerating at about 50% throttle. Pulled over, turned off engine, restarted and all is OK now. My question is, where is the code? I put a reader on and no codes shown. Is there something I can log to look at code history?
I figured it out. When it happened again, I was logging and was able to see the code in the scanner. Very cool! I through the popular P061B, so I increased my allowed error range for now. Will get the torque/inverse torque tables dialed in when I can afford some dyno time.
Last edited by txcharlie; 08-25-2015 at 06:33 PM.
Reply With Quote