Ready to through this hp in the trash

[yfz81]

I installed new cam and for the life of me can not get any drive abilty at all can not get to idle in gear or any thing

[Markmx6]

And it is the fault of the software?

[mowton]

And it is the fault of the software?

^^^^^Touchee......

Would you like some help....?

Ed M

[yfz81]

this is what I have sowe far I installed a comp 54 602 11

[mowton]

this is what I have sowe far I installed a comp 54 602 11

Great cam to learn on.....not!

looking at the tune.

Ed M

[mowton]

Any logs, what have you done? etc.

Ed M

[yfz81]

Any logs, what have you done? etc.

Ed M

let me go out and do a log real quick

[yfz81]

data 4.hpl

[mowton]

For starters pull 1 g/sec out of the BRAF across the board, change idle rpm to 900 and 950 and add 6 degrees of timing to the idle base spark from .08-.28 g/cyl and 0-800 rpm.

Ed m

[mowton]

Question, what is the setup. Is it an automatice? Idf so, what stall convertor?

Ed M

[yfz81]

2800

[yfz81]

Barf ??

[yfz81]

Ok sowe i chang them from 3.095 to 3.094 ?

[yfz81]

SORRY in very new just got this last weekend your going to have to talk to me like im 7

[mowton]

SORRY in very new just got this last weekend your going to have to talk to me like im 7

Here you go....

[yfz81]

I can not figure out how t put the timeing in the table

[mowton]

I can not figure out how t put the timeing in the table

Type it in.....

Ed M

[yfz81]

The same way you have it on your table

[mowton]

Just make the idle timing in red changes. Make it 26 degrees, should be simple. Leave the rest of the table alone.

Ed M

[yfz81]

I did that all ready it idles better but runs worse then what it did the base idle air flow I can not figure out