Does any one know the voltage threshold the computer likes to see during flashing? I recently swapped over from SCT to the nGauge (Lund) and I normally run my trickle charger while flashing. the swap from SCT went well. I then backed up stock tune with nGauge and proceeded to upload new tune. It failed with a code 8 and would let me flash stock tune. I disconnected battery (read 12.4v with metter) and put it to a normal charge. Came back 25 minutes later (voltage now 12.99), reloaded stock tune, then flashed new tune no issues. Yesterday I tried to flash a revision and i bricked again. I didn't have car on trickle charger, but battery was at 12.6v. Again after disconnecting battery and charging it to 13v did the stock reflash and revision flash take.