Results 1 to 2 of 2

Thread: m6 to a4 swap stalls with desired rpm 0

  1. #1
    Potential Tuner Chevrolet's Avatar
    Join Date
    Feb 2009
    Posts
    9

    m6 to a4 swap stalls with desired rpm 0

    I have a 2001 Z28 and I pinned out m6 pcm for 4l65e trans I swapped in, now the car starts fine and dies. I have P/n and in gear rpm set on tables at 1000 and it says desired rpm 0 and stalls once running on data scan. No dtc's set. Any help is appreciated.
    Last edited by Chevrolet; 04-22-2015 at 09:06 PM.
    2001 Z28 Camaro A4 11.0@126mph LS1 street car
    1999 RCLB Silverado 5.3 tow/daily driver low 13's
    1968 Chevy II Nova 417" LS-3 9.50@140 mph

  2. #2
    Potential Tuner Chevrolet's Avatar
    Join Date
    Feb 2009
    Posts
    9
    This was a matter of loading A4 tune in PCM not modifying M6 tune.
    2001 Z28 Camaro A4 11.0@126mph LS1 street car
    1999 RCLB Silverado 5.3 tow/daily driver low 13's
    1968 Chevy II Nova 417" LS-3 9.50@140 mph