Results 1 to 8 of 8

Thread: 2015 5.0 ti-vct no fly zone

  1. #1
    Tuner in Training
    Join Date
    Nov 2013
    Location
    Nashville TN
    Posts
    17

    2015 5.0 ti-vct no fly zone

    hey i was wondering if anyone knew if the 15 5.0 had the same vct no fly zone as the 11-14 car?I also noticed that optimum power mode is disabled in the mapped points config. thanks
    Last edited by taylor476; 03-10-2015 at 12:56 AM.

  2. #2
    Advanced Tuner
    Join Date
    Jun 2008
    Location
    Tyler/Longview, TX area
    Posts
    746
    Just did a compare and 2015 and 2014 have the same Overlap Border.

  3. #3
    Tuner in Training
    Join Date
    Nov 2013
    Location
    Nashville TN
    Posts
    17
    cool. the 2015 i read didnt show the overlap order for some reason.

  4. #4
    Tuner
    Join Date
    Jun 2006
    Location
    Rham, NC
    Posts
    155
    mine doesn't have overlap border table in it and I haven't seen a 2015 read that did have it...have viewed 5 so far, 2 autos (one being mine) and 3 manual cars
    Last edited by toyoguru; 03-12-2015 at 08:27 PM.
    Current toy- 97 SCSB OBS chevy forged 6.0/4l80 combo with a bit of boost..currently back under the knife

    To many previous vehicles to list

  5. #5
    HPT Employee Eric@HPTuners's Avatar
    Join Date
    Oct 2007
    Location
    Crawfordville, FL
    Posts
    2,409
    I'll look into this tomorrow.

  6. #6
    Advanced Tuner
    Join Date
    Jun 2008
    Location
    Tyler/Longview, TX area
    Posts
    746
    My bad guys. I didn't notice that it was grayed out. When I opened just the 15 tune it's not there. Neither is Max Phasing Limit for Intake. Sorry for misinformation.
    Last edited by txcharlie; 03-12-2015 at 09:08 PM.

  7. #7
    HPT Employee Eric@HPTuners's Avatar
    Join Date
    Oct 2007
    Location
    Crawfordville, FL
    Posts
    2,409
    The No Fly Zone is handled differently in the 15s. I'll work on adding the parameters for that .
    Eric Brooks
    HP Tuners, LLC

  8. #8
    Any more info on this? I noticed I'm limited to about 20 degrees of movement on the intake cams. I see in an SCT file I'm playing with that they have some limitations listed under VCT scalars. Just curious on this.