Is there a way to tell the current gear the pcm thinks the 4l60e is in with the scanner? I've tried, but haven't been able to find that option. Thanks
Is there a way to tell the current gear the pcm thinks the 4l60e is in with the scanner? I've tried, but haven't been able to find that option. Thanks
Last edited by 99ls1tj; 12-20-2014 at 10:55 PM.
Add the Transmission/General/Trans Current Gear PID.
I mostly just need to know if the pcm knows whether it's in gear or p/n. I'm currently using a compushift on the trans, but thinking about swapping back to the pcm. I do not have a p/n switch, but was planning to add one. I tried grounding the p/n wire from the pcm but did not get a change in idle speed like I expected from the programming.
Make sure you don't have a scan loaded. Here is what it should look like.
Image 5.jpg
2006 LS2 Corvette
Automatic
2.56 gear
600 HP Edelbrock E Force Kit
No other mods
That was a big help. Thanks alot
Current gear is showing 2. I tried grounding pin 34 on the blue connector, but did not get a change. I then realized I had PRNDL in the programming set to none, so I changed it to PN only, but I still did not gear a change in current gear when grounding pin 34. At this point, I'm inclined to just leave it as is and up the idle a bit since it's only idling around 550 in P/N.