3 Bar Map Linear and Offset Question

[Itllrun]

I have seen many post's about the topic but no real definitive answer on what to enter for proper readings. I have seen the post done by Dstek about the proper voltage and KPA, but for a C5 3 Bar OS it will not let me enter a negative offset. Any help would be appreciated.

Thanks

[mecanicman]

update your hpt version and you should be able to enter negative value.

[Itllrun]

That was the trick! Big thanks to mecanicman! Problem Solved.

[Meyers2211]

That was the trick! Big thanks to mecanicman! Problem Solved.

Running Version 2.24 and can't enter negative values for the 3 bar Bosch #125 ZR1 sensor. 312.50 and -11.25

Now that its machining, wired and everything I really don't want to change the sensor. Is there an update I'm missing?

[mecanicman]

So update it and try, there is a new version of 2.24 almost daily