Is there a conversion I can use to take GM's stock injector data from a E67 ECU and use it on a LS1 computer? The data is all there I just need to know how to convert the X axis values from the E67 ECM to the X axis values in a LS1 vehicle?
Is there a conversion I can use to take GM's stock injector data from a E67 ECU and use it on a LS1 computer? The data is all there I just need to know how to convert the X axis values from the E67 ECM to the X axis values in a LS1 vehicle?
Rev C file hopefully corrects the read only hangup!
Attached is an excel tool I use to go from e67 to e38 and back. I added another column which will interpolate the LS1 values based on its 0-80 kPa axis. It is not "ready for prime time" but I added a few notes to help you. The key is you need to know the rated flow value of the injector at your setups fuel pressure.
Hope this helps.
Ed M
Last edited by mowton; 10-13-2014 at 12:56 PM.
2004 Vette Coupe, LS2, MN6, Vararam, ARH/CATs, Ti's, 4:10, Trickflow 215, 30# SVO, Vette Doctors Cam, Fast 90/90, DD McLeod, DTE Brace, Hurst shifter, Bilsteins etc. 480/430
ERM Performance Tuning -- Interactive Learning ..from tuning software training to custom tunes
HP Tuners Dealer- VCM Suite (free 2hr training session with purchase), credits and new Version 2.0 turtorial available
http://www.ermperformancetuning.com
http://www.facebook.com/ERMPerformanceTuning
[email protected]
ttt -- unprotected version
2004 Vette Coupe, LS2, MN6, Vararam, ARH/CATs, Ti's, 4:10, Trickflow 215, 30# SVO, Vette Doctors Cam, Fast 90/90, DD McLeod, DTE Brace, Hurst shifter, Bilsteins etc. 480/430
ERM Performance Tuning -- Interactive Learning ..from tuning software training to custom tunes
HP Tuners Dealer- VCM Suite (free 2hr training session with purchase), credits and new Version 2.0 turtorial available
http://www.ermperformancetuning.com
http://www.facebook.com/ERMPerformanceTuning
[email protected]