Results 1 to 3 of 3

Thread: Looking for base tune to get car running C5Z cammed LS3 swap

  1. #1
    Potential Tuner
    Join Date
    Feb 2014
    Posts
    1

    Looking for base tune to get car running C5Z cammed LS3 swap

    Long story short i was on a trip to ohio and a jacking pad from a semi trailer in the middle of the road blasted my subframe then got jammed between my subframe and oil pan, blowing a whole through my oil pan draining all the oil and hitting the crank. Sad waste of a stock motor that only had 26k on it.

    So with the forced upgrade i have purchased a new LS3 long block, and am looking for a tune just to get the car running and put a few miles on it to make sure all is well with the new parts.

    Here is my parts list an help is greatly appreciated.

    Brand new GM LS3 longblock
    Tick performance polluter cam package
    Stock LS3 injectors
    LS3 throttle body
    LG longtubes and x-pipe with no cats
    C5Z MAF
    Vararam intake
    SLP loudmouth exhaust
    160* thermostat

    I also have puchased the lingenfelter cam/crank signal converter box, injector adaptors, map sensor adaptor, throttle body adaptor, knock sensor adaptor harness.

    Not sure who im going to have tune it yet, but would like to get the car running and at least put a couple mile on it and know its all good before i take it to the dyno.

    Thanks again for any help,
    -Austin












  2. #2
    Where are you located? do you have the stock file pulled?

  3. #3
    Tuner JnJSpdShop's Avatar
    Join Date
    Aug 2005
    Location
    Western New York
    Posts
    195
    email me your file and I can help you

    Western New York's Performance Headquarters

    716.830.0506