2013-2014 Mustang Automatic in gear limiter

[efiv6]

Hi All,
Can anybody tell me what limits the engine rpm to ( 2000 ) when in gear and the brake is applied ! This is what stops you from heating up the tires or doing a burnout . Any help would be greatly appreciated.
Thanks

[efiv6]

Hummm ! nobody knows ???? Interesting

[rkrebs27]

Ford calls it BOA brake over acceleration...I'm pretty sure getting rid of some of the torque management or resetting to higher number on some of the torque value limits will do away with it....

[efiv6]

Well i think i diabled all the torque management i can find and it still limits rpm to 2000 !!!! Anybody have anymore advice ??????
Thanks

[Russ K]

Raise the Inferred Movement RPM in the Trans General tab.

Russ Kemp

[efiv6]

Thanks Russ I will try this

[dlc_racing]

Sorry for crashing this thread but Im also having this trouble and i already raise the inferred movement to 8000rpms and still have this same.2000 limit any other ideas is a 2013 gt auto

[efiv6]

Yes I also just did this and it did nothing !!!!! I think there is a parameter missing we are not seeing ??? Thats all i can think of !!!

[Eric@HPTuners]

Yes I also just did this and it did nothing !!!!! I think there is a parameter missing we are not seeing ??? Thats all i can think of !!!

Ill double check to see what may be missing

[efiv6]

Ok thanks Eric

[Eric@HPTuners]

Please post the file so I can have a look.

[dlc_racing]

the 22 file is my current for the street the limiter one is the no torque managmet file in that one it lights all the traction and stability control warning lights but that was my poor try to eliminate this annoying issue so please check them eric ,sultan, russ, anyone HELP cause i have a drags with cops permit this weekend and i dont wanna be embarrassed cause ill be the only one that cant do a decent burnout

[Russ K]

Disable the trans torque truncation, and also try disabling the master enabled under torque reduction.

Russ Kemp

[efiv6]

Thanks Russ I tried all that and it still limits RPM to 2000 when brake is applied !
Eric, I will post a copy of my stock file for you in the morning
Thanks

[efiv6]

[ATTACH]46902
Here is a copy of a stock 2014 Mustang 3.7 V6 Auto. file
Thanks

[efiv6]

Eric did you find anything ?????????
Thanks

[Eric@HPTuners]

Eric did you find anything ?????????
Thanks

Update, then look under Engine > Torque Management > ETC Torque Management > Torque Max vs. RPM

Raise the right side up to the max (10,000 Nm)

Let me know if that does not correct it.

[efiv6]

Eric, no this did not correct the issue still limiting rpm to 2000
Thanks

[Eric@HPTuners]

Eric, no this did not correct the issue still limiting rpm to 2000
Thanks

Scan it, and make sure you have Torque Source in the config. Let me see what it is doing.

[efiv6]

Ok will do
Thanks