Originally Posted by
syclnjr
Good morning all.
New to this generation of engine tuning and I need some guidance.
I am working on the tune on my 09 TBSS with an LS2 and I am wanting to go through tuning the VE within using the Bluecat tool and the unused VE Reversion Lo Altd for tweaking it using the histogram logs that I have taken
Anyway I enter the data from the tune into the Bluecat tool and Generate the VE Table for import or copy and paste into the VE Reversion Lo Altd to modify with the values that I pulled from the histogram that I have setup in the scanner and I noticed that VE Reversion Lo Altd. table is referencing Engine Speed and Throttle Position instead of Engine Speed and MAP.
I would think that I wouldn't be able to copy the VE table from Bluecat direct into this with the table referencing TPS% and RPM
I looked at a few E67 tunes and they all have that table referenced the same, same with E38 tunes.
I haven't done a huge amount of mods to the motor so really it probably doesn't need to be tweaked at all but, if I put a cam in I would like to be able to tweak these values using the tools that are out there.
Any insight that you would have on this would be great.
Thanks in advance.
Mike