-
Tuner in Training
Setting up the VE Table
I just went for a long drive to collect some scanning data and now im at the point of taking that data and adjusting the VE Table. This is my first time im going to edit the table, so im a little confused on how it works. Right now the table is blank. How do I load in the data to be able to make % adjustments based on my scan?
-
Tuner in Training
If the VE table was blank I don't think your car would run very well. Are you looking in the right place?
-
Tuner in Training
I think i figured it out. I had to load in the values to the histogram table.