I'm trying to figure out which of these settings to use to enable PE. I have looked at some tunes in the repository and most have PE Enable RPM set very low and PE Delay RPM set to where they want PE to enable. Seems like it should be the other way around based on what is described in the help section. Can someone clarify for me?
Thanks,
Tony
PE Enable
Enable MAP: This MAP value must be exceeded to enable PE mode
Enable MAP Hysteresis: This value is subtracted from the enable MAP value. If the MAP reading drops below this value then PE mode will be disabled.
Delay RPM: PE mode is delayed if RPM is below this value. Set to 0 to disable PE Delay and enter PE mode immediately.
Enable RPM: This RPM value must be exceeded to enable PE mode
RPM Hyst: If enabled, RPM value must drop by this amount to disable PE mode
Enable Torque %: Percent desired torque required to enable Power Enrichment
Torque % Hysteresis: Percent desired torque hysteresis for disabling Power Enrichment