Could they be added to FPAF0A3? 2007 GT. I'm having trouble getting my cat monitor to run as well.Originally Posted by Eric@HPTuners
Could they be added to FPAF0A3? 2007 GT. I'm having trouble getting my cat monitor to run as well.
I have a 2008 GT here with an on3 turbo kit and I'm having a hell of a time getting any of the readiness tests to set. Not sure if I just have it setup wrong or not.
2010 Camaro SS LS3 - Heads, Cam, Whipple 11psi 756whp 663wtq 93 and meth
OS is FPAN054
2010 Camaro SS LS3 - Heads, Cam, Whipple 11psi 756whp 663wtq 93 and meth
never mind i'm dumb, just found it. must have happened when i updated the other day.
2010 Camaro SS LS3 - Heads, Cam, Whipple 11psi 756whp 663wtq 93 and meth
Did you get the catalyst monitor to run? If so could you tell me what you changed? I don't see cat failure ratio under engine diag. Just updated.
The parameters aren't in every definition. Email your file to support and I'll get it added faster.
Eric Brooks
HP Tuners, LLC
Will do. Thank you!
I have a 2009 GT500 and ever since my long tubes were installed and the car was tuned, I am still getting the P0153 and P0133. The tuner has set the delay multiple times and the codes continue to come on. What are the stock values? May just need to start all over again.
Has anyone ever defined what these four parameters are and how they work?OK, parameters added into a few of the Copperhead definitions, including those that asked for it above.
You will want to raise all these values to the max. ;-)
Last edited by dbarbarine; 11-19-2015 at 10:13 AM.
Reply With Quote