Results 1 to 4 of 4

Thread: stalling at idle

  1. #1
    Tuner in Training
    Join Date
    Feb 2013
    Location
    Portsmouth,, VA
    Posts
    40

    stalling at idle

    i have an occasional stall when i stop or put the truck in reverse. i tried searching the forum but the search function is giving me errors. i am taking her in for dyno tuning over the next few months but it is something i would like to correct until then. other than eating fuel and being rich as hell i dont mind how it runs until then. here is my tune as it sits. it was set up by the tuner because i had a bad CPS and we couldnt finish tuning. thanks for the help.
    Attached Files Attached Files

  2. #2
    Senior Tuner mowton's Avatar
    Join Date
    Mar 2007
    Location
    Florida
    Posts
    3,773
    provide some detail on engine and setup please

    Ed M
    2004 Vette Coupe, LS2, MN6, Vararam, ARH/CATs, Ti's, 4:10, Trickflow 215, 30# SVO, Vette Doctors Cam, Fast 90/90, DD McLeod, DTE Brace, Hurst shifter, Bilsteins etc. 480/430

    ERM Performance Tuning -- Interactive Learning ..from tuning software training to custom tunes
    HP Tuners Dealer- VCM Suite (free 2hr training session with purchase), credits and new Version 2.0 turtorial available
    http://www.ermperformancetuning.com
    http://www.facebook.com/ERMPerformanceTuning

    [email protected]

  3. #3
    Tuner in Training
    Join Date
    Feb 2013
    Location
    Portsmouth,, VA
    Posts
    40
    LS383, PRC stage 2.5 5.3L heads, comp 228/234 @.585/.595 112lsa, 11.5:1 compression, NNBS intake,FAST 57 lb/hr injectors, 90mm edelbrock TB, ARH long tubes, high flow cats, jakes stage 3 4L80E, circle d 3600rpm stall, 4.10 yukon gears, tru trac,

  4. #4
    Advanced Tuner
    Join Date
    Sep 2013
    Posts
    427
    greasemykey.....mate what sort of car is it? just had a look those underspeed/overspeed tables are those stock and how does it idle or how well does it idle?....the ve map down low in idle conditions looks lean to me......I don't know much about you fuel set up but the injector flow rate don't look right......if you can post up a scan so we can see what is happening when the problem occurs mate...cheers Bret