-
Tuner in Training
Injector data
I am trying to copy and paste injector offset data into into my tune from a spreadsheet i recieved with my new injectors but every time I go to paste the numbers they end up changing. I think it is trying to round the numbers but some of them seem to be off quite a bit off.
-
Senior Tuner
try showing more decimals in the editor...
also, some values will be rounded due to file structure and hexidecimal limits...totally dependent on the architecture of the ECU being used
-
Tuner in Training
Thanks for the response. I did increase the decimals. I am running a 411 pcm if that changes anything.
-
Senior Tuner
its just a limit of the pcm...not enough bits to give you a higher resolution...it can only fall on values that match the Hexidecimal resolution of the Computer Code.
I would not worry about it too much.
-
Tuner in Training