Scanner histogram ?

[gmtechnician]

I was trying to log a 2008 Chevrolet 1500 4.8L and the ltft ve histogram said:

"This Histogram is not supported with the current loaded parameters.

If this Histogram references Tables, it is possible that the vehicle
you are connected to does not support these Tables. It is also possible
that the sensor required for the Table is not found in the loaded
parameters.

If this Histogram references Sensors, it is possible that the sensor
required is not found in the loaded parameters.

If this Histogram references PIDs, it is possible that the PID required
is not found in the loaded parameters.

You will find all of your loaded parameters located on your Table Display.
To add more parameters, right click the table display and click insert.

For example, if you have a histogram built that maps Timing Advance
and you do not have Timing Advance inserted on your Table Display,
the Histogram will not function."

I was using the default config. I have never ran into this before. What do I need to do?

[planethax]

Your are not logging a parameter in the main Table that the Histogram needs.
Post log and config

[PICNIC_GEORGE]

Your are not logging a parameter in the main Table that the Histogram needs.
Post log and config

These threads could be avoided if HPT said what PID you need to log for a certain hist to work.

[Bill@HPTuners]

The AI to do so would be very difficult to implement, ultimately you are attempting to use histograms originally intended for a 2002 Camaro or Firebird on your 2008 Truck and just isn't going to work out as well as you might want it to. You will need to customize your histograms as you see fit.