Setting GM 3.6L MAF Frequency Fail

[TurboAlloytec]

Hi everybody,

Firstly, I hope this is the correct place to post this...

I own a 3.6L HFV6 in my 2007 Holden Commodore, which has recently had a turbo strapped to it.

I am running an aftermarket ECU to control fuel and whatnot, but left the stock ECU in place for all the other functions.

I am having a problem with P0101 and P0103 DTCs - I've set them to '0 - disabled' in the DTC table, and now no MIL is shown, but they still trigger my traction and stability control to disable, resulting in annoying beeping and flashing lights.

I have been able to set MAF fail parameters on other vehicles, but I can't seem to locate it in any obvious place - is this feature unavailable, or am I just really bad at looking for things..?

[MMGT1]

Should post a tune there so others can have a look and see if they find something you may have overlooked

[Bill@HPTuners]

depends on the pcm, if its an E55(bosch variant) its not there because the ve tables are not available so tuning with no maf would be next to impossible.

[TurboAlloytec]

Ah, ok that makes sense I suppose, thanks for the response!

In my case, the MAF has no say on fuel metering, it's just there to keep everything happy.

Is there anything I can do that will solve my problem?
Is there a way I can run no MAF while keeping everything happy? (Traction/Stability control mainly)

[dan_t]

Having a similar issue - has there been any resolution to this?

[MarkTucker]

Having a similar issue - has there been any resolution to this?

What is your specific issue? This is a pretty old thread.