hi, I'm pretty new to tuning. Ive done a few ls1, gen III and IV swaps, but I'm embarking on building a cool foreign car with fuel injection. I have a 1979 Toyota corolla with a 2tc engine. I have a complete 1999 cavalier and I wanted to try to adapt the pcm, harness and sensors over to the corolla. I can figure out the fabrication of the intake manifold, throttle body, map, tps, iac, knock sensor, iat, cts, and fuel system. I'm just hesitant as far as the crank sensor and cam sensors. I believe the reluctor is 24x on the cavalier so i was thinking of a fabbed setup, but on the cam sensor I was wondering if there was a way i could send the signal from a efi toyota distributor to the pcm. Any help or ideas would be greatly appreciated.