This is my first post here as I just got my Hp Tuners over the weekend. I haven't had a chance to get a log of anything yet, but hope to very soon.
well, i've hit a bump in the road with my project. over the last few weeks i've been focusing mostly on wiring. i completely separated the GTO harness and depinned the PCM connectors to remove stuff that's not needed and to extend the wires to locate the PCM in the car. I'm at the point where i've been trying to get it started.
Here is where i'm at. Motor cranks just fine. i get one combustion cycle from initial starting crank - here's a vid IMG 0462 - YouTube
Here's my setup and what i've done for trouble-shooting
1991 240sx
2001 LQ4 (Wiseco 4.030 -15cc pistons)
EPP Blower cam 232/240, .595/.604
T76 turbo
Fbody T56
-2004 GTO PCM (GEN 3) and harness (emissions stuff removed)
-VATS set to NONE
-No MAFS (DTC's still enabled - P0101-103) will update this asap
-Bosch 044 fuel pump - 60psi at the On and Start positions (via aeromotive FPR)
-60lb Siemens injectors - have been flow tested and are not stuck
-motor runs when spraying starting fluid constantly through the intake
-Noid light test done - very, very faint light comes on with the first initial crank but nothing after that. this was the same across all 8 cylinders.
-Gave injectors 12v power and grounded all 8 injector pins in the Blue harness connector along with Noid light tester and each injector plug lit up.
-I thought the injector drivers in the PCM were bad, so i bought a 2nd PCM and had flashed to the same tune as the original PCM, same result.
-I've checked the PCM constant 12v pin and the 2 ignition pins in the PCM connector and get battery voltage
-I've checked all 8 ground pins in the PCM connectors and get less than 2 ohms resistance (.8 IIRC) at each one
-I had a friend with HP Tuners come over a couple weeks ago and scan the PCM while cranking to see what's going on. Getting no injector pulse width at all. everything else is registering.
Since it runs off straight starting fluid, i can pretty much rule out everything but the injectors (atleast i think)
I've attached my current tune file. I've been trying to compare similar tunes from the Repository and see if anything stands out, but not having much luck just yet and am still getting familiar with the software.
Thanks for the help!