Bill,
Ive already asked for access to tune the zf 6 speed auto from 2005 onwards and got no reply.
If that isn't possible, could we please atleast get the ability to do a TCM reset on the gearbox module so we can reset the adaptive learning.
Ive started rebuilding a few of these so far and the behave like 2 dollar hookers for 1000-1500ks without a reset. That is risking torching all the new frictions/steels!!!
Also i would like the ability to run a 4 bar map sensor as the stock one maxes out at about 23psi depending on sea level etc.
Thank you in advance for your time and consideration.