Real time tuning Vehicle cell trace not working in 2.24

[mulot30th]

I selected follow vehicule in bottom of the rtt screen... still no way to see that trace cursor.

I had used this in release 2.1 with no problems, now with 2.24, not working anymore?

tuning a 1999 ls1 transam

this is the idle rtt mode.

need help please thank you

[dbrods]

I just noticed I'm having the same issue as above. It worked fine on 2.20 and now that I updated to 2.24 the tracer is missing in the real time charts.

[mulot30th]

I just noticed I'm having the same issue as above. It worked fine on 2.20 and now that I updated to 2.24 the tracer is missing in the real time charts.

look like we are facing a software bug?


what is latest working release with trace in rtt working?

[Bill@HPTuners]

should work fine, need to make sure its turned on(bottom right hand corner of the RTT window)

[mulot30th]

I have turned it on (bottom right corner of the rtt window, selected "follow vehicle"), tried turning it off, then scanner off, turn it on, scanner on,, etc... every combination, and found no way to make this work.


not working plain and simple.


What is the latest release that I can downgrade and get this feature back to working, I need this?

[dbrods]

I set the Table cell mode to Follow vehicle and it does show you the tracer now, but will only allow you to adjust the cell that its in. When I set Table cell mode to User selected it does not show the tracer but it will let you adjust any cell you want. It kinda sucks cause 2.20 would let me see the tracer and adjust any cell I wanted to at the same time. Made real time tuning nice. Any way we can get this changed to how it was before?

[mulot30th]

is there a place to download that version 2.20? now

i would prefer to go back than not being able to trace in rtt

thanks

[mulot30th]

i can even make a video showing it not working if that could help?

[mulot30th]

Anyone, have that release 2.20 so I can use rtt with the trace?

I need this please, do not want to wait till next release way too long.

[MikeOD]

Anyone, have that release 2.20 so I can use rtt with the trace?

I need this please, do not want to wait till next release way too long.

There's new releases every couple days if not more often...the link to 2.24 on your customer center is always linking to the latest version, make note of your version number (2.24.xxx) download, install, and check again, and try it.

[mulot30th]

Did not knew that.


but I have the very latest one and its not working as of now.



I have no use for the rtt if I can't have that live trace cursor showing up. I'll just go back to using histograms on replay data instead..... until I can get that feature back to working.


Unless I can get an earlier release that is working.... I do have release 2.1 here. but this is quite an old one... not sure I would like to go that much back .. but was working flawlessly in that one.