Hi everyone,
I am trying to get started on my first 2 bar sd tune, my problem is I can't get a map reading above 105 kpa even though it's boosting 8psi by my mechanical gauge. I'm sure it's something simple, but i'm stuck.
Thanks for any help
Al
DO YOU OWN A FORD, DODGE OR GM ALLOYTECH VEHICLE AND GET A MESSAGE SAYING "VALIDATE CHECKSUM FAILED. YOU WILL BE UNABLE TO SAVE OR FLASH THIS FILE." IF SO FOLLOW THE LINK BELOW.
I have a map reading in the scanner but it maxes out at 105kpa, even when boosting. I do have a 2 bar sensor in there,
I'm thinking I may have selected the wrong setting?
DO YOU OWN A FORD, DODGE OR GM ALLOYTECH VEHICLE AND GET A MESSAGE SAYING "VALIDATE CHECKSUM FAILED. YOU WILL BE UNABLE TO SAVE OR FLASH THIS FILE." IF SO FOLLOW THE LINK BELOW.
Hey Fullthrottle, thanks a lot for your interest and help, I figured it out, not exactly sure what was wrong but I loaded default settings and then added "pid" map 2 bar, then took it for a drive and bingo, it works and seems to be accurate according to the wastegate setting and autometer mechanical vacuum/pressure gauge.