How does one accomplish this? I have been multiplying the Engine>Torque Management>Engine>AC Torque vs. AC Pressure table but I really have no reference on what I'm doing.
Before I started my STIT would go to like 30+ when the AC turned on, so I kept adding to the table so now its close to 0 STIT. But its not consistent, It seems to start off positive STIT but after a while it will end up negative STIT even with the same logged AC voltage.
Also does anyone know what AC sensor voltage = what pressure? I can log voltage but that doesn't help if I don't know what pressure that equals. I have seen a chart that showed a liner 1volt=100lbs but it wasn't LS specific.
Thanks,
Dave