The pid that I have been trying to create to log afr err is not working, says 'parameter not supported' when I begin to log. It says the same for AFR command. Im just using [PID.6001] for the afr command. This is on a 2002 silverado. Does this pid not work on these ecms?
Last edited by cfaluck13; 06-16-2013 at 09:45 AM.
'02 Silverado-4.8T mp70
Nobody?
'02 Silverado-4.8T mp70
For me it is [PID.6000] and they have to be loaded in the table window to work elsewhere in the software (not knowing if you knew that).
Yes thats where im trying to use it at, nobody else has run into this?
'02 Silverado-4.8T mp70
You need to log air fuel ratio commanded high resolution in the table display.
2000 WS6 Trans Am LS3, Tick Performance Stage 2 cam, ARH 1 7/8" Headers, FLT Level 6 4L60e, Circle D 5c Launching on a 200K 10 Bolt
2001 Camaro SS M6 Black on Black
Reply With Quote