Results 1 to 2 of 2

Thread: Buick 3800 V6 Rock Bouncer - Tuning info

  1. #1
    Tuner in Training
    Join Date
    Jul 2011
    Location
    Camden, Arkansas
    Posts
    20

    Buick 3800 V6 Rock Bouncer - Tuning info

    Well I thought I'd post up a little about my project. Hopeuflly, I can gain some insight concerning tuning a setup like this



    Series II 3800 with 8.0 comp Diamond pistons
    Iron cylinder heads Heavily worked over (all you can do) with 130# valve springs
    powdered rods and ARP everything
    camshaft is a turbo cam specs--- duration @ .050": 226º/218º, lobe lifts: .343"/.346", valve lifts with (stock)1.60:1 rocker arms: .549"/.553", lobe separation angle: 116º, intake centerline: 110º
    running F-body intake setup
    my turbocharger is a Holset HE351v varible with a 60mm compressor wheel
    the exhaust housing will go down to a 3-6cm and opens to approx 28cm
    Intercooler good to 600Hp (as advertised )
    Fuel injectors are Racetronix 120# and have AEM injector driver modulue and harness
    Running a Fix frequency Mini AFC

    I am using a wastegate actuator to control the opening of the turbos.
    I have a TiAl 38mm wastegate and a 50mm BOV


    My goal is 650 Horsepower with hopefully near INSTANT spool.... I have a 3000 Stall I'm using a Full built PTC th400. My axle ratio 6.72

    I am using Hp tuner

    What I haven't gotten and would like recommendations on -

    * Inline fuel pump
    * Fuel rails
    * which throttle body ( All my stuff was 1997 )
    * MASS AIR (stay stock and rescale?)


    I have no info on the injector driver setup as to how to 'tune' for it... Help appreciated

    Below are a few pix of the general build...

    Any comments would be appreciated and THANKS!!!!
    Attached Images Attached Images

  2. #2
    Tuner in Training
    Join Date
    Jul 2011
    Location
    Camden, Arkansas
    Posts
    20
    a few more pix...
    Attached Images Attached Images
    Last edited by TURNEROFFROAD; 04-28-2021 at 05:58 PM.