I have done a lot of searching and reading on this site on this issue.
Since I have started tuning my car it has developed an INTERMITTENT shift flare mainly on the 2-3 shift. It also something does it on the 3-4 shift as well. The flare is only on light throttle and light load. Higher throttle and load the shifts are fast and tight.
From what I read I should use the adaptive learn reset feature on HPT scanner after each reflash.
I also read that I could try disabling adaptive pressure upshift adapt.
others suggest to zero out all adaptive pressure preset (oncoming and offgoing) tables.
Most of the above suggestions are somewhat dated so I was looking for any updates you guys might have.
Tune attached if you are interested.
thanks in advance!
-Jason