Is it possible to run both a ScanGauge and our Interface simultaneously from the OBD-II Port?
Is it possible to run both a ScanGauge and our Interface simultaneously from the OBD-II Port?
Just in case anyone is wondering the answer is Yes.
How did you do it? I have an Edge Insight CTS plugged into my Duramax, and I'd like to datalog, and leave the Insight plugged in at the same time.
Just wired in a second OBDII Port in Parallel, I’m assuming there will be a hit on bandwidth if you try to log a lot of data but for my purposes it seems to work well.
Ah, good thinking! Now I need to find an OBD2 port and wire it in.
That's handy, thank you for the link. I think one of my buddies is parting out a Chevy truck, I'll check with him first.
LOL no probs very welcome, I had one from my old V6 loom so used that but ordered some "spares" from that site for the other car!
(might even install a third in a less annoying more easily accessed spot)
Can't see any reason why not, a bud had suggested one but I didn't want more cable clutter between my legs
word of warning, do not have 2 devices connected when flashing.
Did it on mine without an issue.Originally Posted by 1998Ws6
I drove threw a Red Light without issue.
LOL Just Kidding.
You may get away with it a few times but it drastically increses the odds of messing with the flash as an aux device' data chatter could interfere with the flashing process.
LOL no probs point taken
Reply With Quote