Results 1 to 4 of 4

Thread: RTT tuning

  1. #1

    RTT tuning

    Dos any one know how to or if its possible to, when you use rtt
    When your doing ve table if your on the dyno as you load each cell
    How do you get the + and - keys to work so that you can just use two fingers
    To increase and decreas fuel in each cell as you go it seems dumb that you have to stop
    In each cell and type numbers any help thanks

  2. #2
    Senior Tuner Ben Charles's Avatar
    Join Date
    Aug 2009
    Location
    Calibrating
    Posts
    3,371
    You can have it commanded to follow the vehicle or follower user. Have it follow vehicle and use the + and - on the computer to add or subtract, VERY EASY.

    Email Tunes, [email protected]
    96 TA Blown/Stroked, 4L80E/Fab 9
    15 C7 A8 H/C 2.3 Blower/PI
    14 Gen 5 Viper
    Custom Mid Engine chassis, AKA GalBen C

  3. #3
    Quote Originally Posted by Ben Charles View Post
    You can have it commanded to follow the vehicle or follower user. Have it follow vehicle and use the + and - on the computer to add or subtract, VERY EASY.
    Thank you sir I will give that a try tomorrow, I will have to figure out
    Where you change it to follow me or the car but ill do it thanks again for the help

  4. #4
    Senior Tuner Ben Charles's Avatar
    Join Date
    Aug 2009
    Location
    Calibrating
    Posts
    3,371
    Once you have the RTT up on the scanner and running, its in the bottom right hand corner.

    Email Tunes, [email protected]
    96 TA Blown/Stroked, 4L80E/Fab 9
    15 C7 A8 H/C 2.3 Blower/PI
    14 Gen 5 Viper
    Custom Mid Engine chassis, AKA GalBen C