Looking for Exact Fuel Injector Table Values Bosch 0280155811 electronic fuel injecto

[JamesLinder]

Could someone PLEASE confirm exact numbers for all the HP Tuners tables

I have verifed that these are NOT the same as the older Bosch 868 injectors, however below
are some other part numbers mine are also referrenced under.


BOSCH #280155811
GM # 2171389 or 24508208

I got what I needed; these were used in some of the ASA C5 Vettes. Thank you James Short of KY
for providing the data.

[Ben Charles]

Can anyone confirm whether or not the the other injector characterization tables truly can be left the same as they were with the smaller, stock OEM injectors?

James you can probably get away with it, but if you notice a larger injector PW then play some of the tables to lower the injector PW.

For example uou have your car tuned at the moment and say your at 2.8 injector PW bank to bank, swap in the new injectors with the new flow rate and there 3.5, then play with the tables to lower it back to the 2.8

[Ben Charles]

Thats cool, Im an Arkansas native too

[Russ K]

These are the injectors I have in my 418, http://www.compperformancegroupstore...Category_Code=

Just set the IFR table, and done, plus they are only $331.35 for 8.

Russ Kemp

[TDCRacing]

These are the injectors I have in my 418, http://www.compperformancegroupstore...Category_Code=

Just set the IFR table, and done, plus they are only $331.35 for 8.

Russ Kemp

Russ, would you please share your HP Tuners table values that you used for IFR vs Kpa vacuum. Did they give you a flow test sheet for them?

The ones Russ Mentioned are 868 injectors, Multiple tables for the 868 injector can be found in this thread...

http://www.hptuners.com/forum/showthread.php?t=41650


I just figured it may be of some use to you.

[Russ K]

Russ, would you please share your HP Tuners table values that you used for IFR vs Kpa vacuum. Did they give you a flow test sheet for them?

40.4 @ 0 Kpa & 44.2 @ 80 Kpa. No flow test sheet.

Russ Kemp

[JamesLinder]

I have confirmed that what James Short posted works perfectly for the subject injectors which I have. See attached, and use the IFR table, the short pulse table, and the offset table.

[JamesLinder]

I got even better results with these revised IFR settings.

[Malejyetti]

Hi, did you get the data sheet for those injectors?

Thanks

Petr

Could someone PLEASE confirm exact numbers for all the HP Tuners tables

I have verifed that these are NOT the same as the older Bosch 868 injectors, however below
are some other part numbers mine are also referrenced under.


BOSCH #280155811
GM # 2171389 or 24508208

I got what I needed; these were used in some of the ASA C5 Vettes. Thank you James Short of KY
for providing the data.

[dermotw]

This thread is 3 years old! But anyway, look at this one;

http://www.hptuners.com/forum/showth...njectors/page3

[1972C10_LS]

I have confirmed that what James Short posted works perfectly for the subject injectors which I have. See attached, and use the IFR table, the short pulse table, and the offset table.

Do you still have the injector info for these injectors? It says see attached but Im thinking since this post is so old the links or attachments are gone?

Thanks!