Ok so I have my NGK AFX WB wired directly to the battery on a toggle switch on the ground side and analog output wired into pins one and 5 of EIO. my Im attempting to log Lamba error. My formula for lambda is put in as V/10.42 +.62 using commanded Lambda to compar however my AFX box reads around 14.20 and Lambda error display in the tables read .75 lambda yet when I drive down the road floor it anything the reading in the table NEVER changes other than .75 to .76 and when I log err against MAF frequency I get 1 across the histogram like everything is fine. Ive got a CAI and 1 7/8" primary headers why arent I getting any MAF error and why if my formula is correct isnt my tabled Lamda err never changing?!