The car is an 09 G8GT with LT's,CAI and a Yank 3200.
I can be going say in 6th gear, punch her, the trans would donwshift to 2nd, then there is pause in acceleration, then off she goes at full throttle in 2nd gear. initially i thought i had my powerdownshift's set to quickly, and the trans was adapting pressures or whatever to my new verter (had it installed last week), yesterday for shit and giggles, i took a couple of logs when this event was happening, and to my surprise, she's is closing the throttle down right when i see the trans shift into 2nd. I logged etc source, etc tgmgt type and torque mgtm advance.
when i go WOT, etc tqmgt type is "none", etc source is "maxpos"
When the throttle closes, etc tqmgt type goes to "trans", and etc source goes to "idle"
then the throttle opens up again, and off she goes.
How can i fix this little issue ? i have set the spark min tgmgt to be 2*, this have worked in the past for the hesitation on power downshifts, i just didn't notice the throttle closing like this before, this of course slows down the car in the moment where you most need it under special circumstances , this doesn't seem to happen when the trans has to downshift 1 gear down, example from 4-3 or 5-4, at least doesn't feel like the pcm is closing the throttle, i don't have a log for that one though. my TM master switches are stock, i want TM, not just like this much.
Attached you'll find a couple of logs and the config file i have.
Thanks.