Idea is, I need to limit boost in 1st gear, and my boost controller can use momentary switch to change between low/hi boost modes. So I'm trying to figure out is it possible to make that switch "click" programmatically via MVPI output?
Idea is, I need to limit boost in 1st gear, and my boost controller can use momentary switch to change between low/hi boost modes. So I'm trying to figure out is it possible to make that switch "click" programmatically via MVPI output?
LS1 383ci 98' FBody, turboed, 00' PCM, 4L80E, 90# FIC injectors
110ci Nissan 200SX, 25psi, 370whp
I think I'd use the harness electrical signals and "glue
logic" (or maybe just relay logic, simpler yet), just so
I didn't have to drive with my cable plugged in all the
time.