help with maff vs stft

[robfromlouisville]

I need help with how to put a maff hz vs stft configuration in my histograms

[jimmyb496]

Under General & Plot tab: Plot Value Sensor: STFT
Change high to 20/low to -20 (unless you think your values will be off higher or lower).
You could add filter [PID.68]=1 which should only log when in Closed Loop, but that is optional.

Under Row & Col Axis tab: Primary Table I selected Mass Air Flow Freq from the list your vehicle made available. That populated the Top Axis w/ what should be correct labels matching the table in your ecm editor.

I'd start there and see how that works.