Results 1 to 5 of 5

Thread: 2010 Camaro Cam instal Issues

  1. #1
    Tuner in Training
    Join Date
    Aug 2011
    Posts
    17

    Post 2010 Camaro Cam instal Issues

    I've just installed a cam and cant get it to idle. Cranks just fine but onse it idles for 3-5 seconds it starts backfiring, so I just cut it off. I have the Tune and scan below. I'm new to tuning, so I could have butchard the tune horribly. Construuctive critisizm welcome.
    Last edited by Tundramaro; 07-20-2012 at 10:22 AM.

  2. #2
    Tuner in Training
    Join Date
    Aug 2011
    Posts
    17
    Sorry guys. It's a 2010 Camaro with a .617 intake .615 exaust 231/242

  3. #3
    Advanced Tuner
    Join Date
    Jun 2009
    Posts
    203
    did you disable DoD and varibale camshaft... I got that problem once

  4. #4
    Advanced Tuner
    Join Date
    Jun 2009
    Posts
    203
    sorry, is a manual .... maybe start from stock and just gei it on 20 degress timing on iddle and adjust minimum airflow... 2 grams more and set iddle to 1000 rpm so you just keep it runnin to improve your tune

  5. #5
    Senior Tuner
    Join Date
    Sep 2008
    Posts
    1,668
    Read through the notes in this thread...especially the procedure in post 85, and there are some other notes after that that can help too. http://www.hptuners.com/forum/showthread.php?t=15564 If you disable closed loop and follow that procedure, the car will idle rock solid when you're done...it works incredibly well.
    Last edited by MikeOD; 07-20-2012 at 02:24 PM.
    2010 Camaro SS M6. Stock Bottom End, Heads/Cam/Intake/Headers/Exhaust.
    2005 Silverado RCSB. Forged 370 LQ9/Borg-Forced Inductions T6 S484/Jake's Stage 4 4L80E with D3 Brake/4WD.
    2023 Durango Hellcat