2007 Z06 2bar Tune Timing

[boostls2]

Edit - solved timing issue but now when i get into boost it only reads up to 106kpa in the histogram, not sure if something is off? Why wont it read any higher?

map is p/n 12591290

[Bill@HPTuners]

any reason why you are trying to command a 24:1 air fuel ratio?

You also have the map sensor set as a 1 bar map sensor so there are two issues right off the bat, I can't imagine what other is out of wack

[Bill@HPTuners]

You should set all 3 VE tables to the same value.

[Bill@HPTuners]

maf tables really need to have some valid info, stock maf tables would be a good starting point. Even if you set the maf fail freq to 0 we recommend putting the stock maf tables in there rather than leaving them blank.

[boostls2]

Where do I have it ser as a 1 bar map? Where would I change this? Sorry, used to the gen 3 cars and this should work as is as far as I know

[boostls2]

I'm also having a hard time determining if the map is in fact a 2bar map

The scale is set high to trick the vcm for the 85# injectors

[boostls2]

You should set all 3 VE tables to the same value.

I tested the voltage on this map and it appears it must be a 1.5bar map because car off ignition on, the voltage reads 3.9v.

How do I set the map max value ???

[Bill@HPTuners]

under the engine diag tab

[LSxpwrdZ]

No offense but a fragile LS7 with boost isn't the setup to be figuring this kind of stuff out on. Your window of error is very small with them.

[vette_c6]

with all respect

take your car for a tuner ,, or you will break the engine very fast