We finish installling a turbo to a 2010 silverado, Its a 76mm on a stock 5.3
Heres my file want to be sure if its on pure MAF, just waiting on the injectors and the scanner that i did with the file stb1 n 2 are way off.
We finish installling a turbo to a 2010 silverado, Its a 76mm on a stock 5.3
Heres my file want to be sure if its on pure MAF, just waiting on the injectors and the scanner that i did with the file stb1 n 2 are way off.
I dont get why my stb1 and 2 are still on...
It's in MAF mode. You still have fuel trims because your O2 readiness ECT isn't set correctly. Set that to 400 or something unachievable.
FWIW, I don't like setting things to zero (your dynamic airflow). I'd rather there be something in there, like 200 or something.
EFI specialist
Advanced diagnostics, tuning, emissions
HPtuners dealer and tech support
email=[email protected]
O2 readiness ECT its at -40, change it up to 400?
Heres the update file.
Last edited by 02Ls1; 05-29-2012 at 01:19 PM.
My stb1 and 2 were way off because one of the injectors was not sitting down right, about to log it see what it does still eaiting if my file is good to go...
I upload the file and took off the bank 2 sensor 1 off of my down pipe to install the wideband, now i getting codes that are from the sensor i took off is this normal till i install it back?
p0050
p0154
po155
EFI specialist
Advanced diagnostics, tuning, emissions
HPtuners dealer and tech support
email=[email protected]
Thanks...