I searched the forum to see if there was an update on clutch relearn being added to HPT. Is there any update on this?
DV
I searched the forum to see if there was an update on clutch relearn being added to HPT. Is there any update on this?
DV
from memory its already there.
I count sheep in hex...
It's there but grayed out on 2008 corvette e38. What am I missing?
DV
please contact support with a VCM Suite Info file while connected to the vehicle.
I count sheep in hex...
what does it do ...any more information please ?!!
specialize in: V8 Conversion & Tuning (UAE- DUBAI)
supercharge installation
Salah clutches for Nissan, Toyota and GM car
I don't think 2008 Corvettes use the variable clutch position switch. That's probably why it is greyed out.
DSX Tuning - Authorized HP Tuners Dealer
http://www.dsxtuning.com
http://www.facebook.com/dsx.tuning
Just say no to bull s***.
IF YOU WANT HELP, POST A FILE!
No idea but new Camaros have the variable pedal sensor.
DSX Tuning - Authorized HP Tuners Dealer
http://www.dsxtuning.com
http://www.facebook.com/dsx.tuning
Just say no to bull s***.
IF YOU WANT HELP, POST A FILE!
The later models have a rotary switch to tell the ecm where the clutch pedal is. Earlier models just have switches. One at the top (cruise disengage) and one at the bottom. (nuetral safety/engine startup). If you change your pedal travel, let's say you put a Tick adjustable clutch master cylinder then a "clutch pos relearn is needed.
DV
it tells the ECM where the bottom of travel point is.
BTW, i think i have fixed this in the newest beta 2.23.602 or later
I count sheep in hex...
Thanks Chris. I'll shoot bill an email and get the latest beta. I currently have 2.23.546.
Thanks
DV
I got the latest beta. Clutch Ped Learn is no longer grayed out. However it is non functional. Click button and nothing happens. FYI
Thanks,
DV
you hold the clutch fully depressed (or where you want the max position to be) then click the button
I count sheep in hex...
Ok. Thanks. I'll try it again.
Thanks,
DV
key on, engine not running.
Ok i added some new PIDs in the scanner so you can see the Clutch Learn Status and the Clutch In Learned Position and the Clutch Out Learned Position.
You'll need version 2.23.620 or later to see them.
The 6 states of the Clutch In Learn Status are:
- Disabled (learning is diabled)
- In Progress (learning is active)
- Pass (learn suceeeded)
- Fail Low (learn failed due to pedal position being below learn low limit)
- Fail High (learn failed due to pedal position being above learn high limit)
- Fail Moving (learn failed due to pedal position not being steady enough)
I count sheep in hex...
From the grave, could someone tell me where the location of the relearn button is? Also, does anyone know how high it will allow it to learn? IE will it learn in a clutch stop set very high for a RPS triple disc which engages high?
Edit; it's in the scanner, and yes it will learn a very high position as 100% disengaged. Works great.
Last edited by VetteTuning; 03-11-2013 at 06:10 PM.
2010 Corvette grand sport Manual.