for datalogging? Something that we could connect to the HPT interface cable?
I never thought I'd tune a Duramax, until I bought one.
for datalogging? Something that we could connect to the HPT interface cable?
I never thought I'd tune a Duramax, until I bought one.
Bump?
Yes, check out the elite series from autometer, data output ports
would you use the gauge to connect to the interface cable going this route?
Jimmy
2005 LLY 4x4 3500 DRW 4 door
AFE 4" Exhaust, AFE Stage II Intake (w/ Bladerunner), HPTUNER software!
2012 Keystone Raptor - 41ft 18k lbs
multiple smaller toys/ trailers/ campers
The gauge has a low output wire (orange), this is what I am connecting to the EIO pin 3, then I will configure a custom pid unless I can find one for it.
Update, the output wires for the elite pyro do not work with EIO as I intended. The elite gauge has two wires one to signal low point and one to signal high point that could be use to activate LED or relay. Back to square one...
worst case scenario and i do this with my analogue pyro gauge
video record the laptop and the gauge refer frames
tedious but it works as a last resort
stock 99' LS1 + powerglide
gt42 a/r 1.06
#80lb siemens @ 43.5psi rail pressure on E85
return fuel system runing 1:1 FPR
aeromotive A-1000 pump
2 bar SD tune
I was informed that this set-up will work with the HPT:
http://aeroforcetech.com/products_sensors_egt.html
I sure hope it does because I'm ordering it lol
Jimmy
2005 LLY 4x4 3500 DRW 4 door
AFE 4" Exhaust, AFE Stage II Intake (w/ Bladerunner), HPTUNER software!
2012 Keystone Raptor - 41ft 18k lbs
multiple smaller toys/ trailers/ campers
Reply With Quote