Scaling 60lb's... 1st try

[02Ls1]

Ok guys i search till i found the data for the Siemens DEKA IV ( DEKA 4 ) Mototron 60lb/hour High Impedance Injectors.

Since this is my first time scaling them on my file (2010 Gmc) i want to ask if i did it right.

I read the excel sheet with the scaling information and whent from there, trying to see if i did it right

Heres the file.

[Beatdown Z]

Here's what I came up with for the flow rate. May not be exact, but should be close. Also, your short pulse adder is off.

[Beatdown Z]

For the short pulse adder, fill in the cells manually by matching up the msec. Half the table is going to be zeroed, so it shouldn't be too bad.

[02Ls1]

Updated the file with the flow rate but cant get the short pulse adder manually, cant get down or close to the one on the sheet. If i get it down its will be off too.

[Beatdown Z]

Read this thread about why the numbers change, just so you know. http://www.hptuners.com/forum/showth...328#post247328

[02Ls1]

How this one looks...

[Beatdown Z]

Looks good.

[02Ls1]

Ok well im just waitting on a harness connecter that i lost from the injector to install them..