What is the best way to set up my Scanner to log cold starts. I have my VE table +/- 2%. After my car sits over night i have a lot of RPM surging and stalling until car warms up.
What is the best way to set up my Scanner to log cold starts. I have my VE table +/- 2%. After my car sits over night i have a lot of RPM surging and stalling until car warms up.
Search Russ K's Idle Config and run thru that, sounds like a good place to start...Mod's?
make a histogram to log your OLFA vs Coolant Temp vs MAP table. With a cold start you can see what is doing on as it warms up and adjust it accordingly in the proper cell in that table.
surging is usually running too rich from what I have found.
'02 Corvette
LS6, MN6, LT's/X pipe and TI's, Honker CAI, AI 243 heads, PatG Custom Cam, FAST 102, LS2 TB, Red Top inj, HPTuners & NGK/AFX
sorry the clutch went out in my car lol. I just got it up and running agian. Thanks for the help.
mods and a comp .581/588 224/230 cam trickflow 215cc heads Fast 92/92 ls2 injectors electric water pump march crank pulley qtp headers with cats and magnaflow catback fidanza flywheel and ram power grip hd clutch.