Results 1 to 5 of 5

Thread: Editing "I" and "L" settings - 4t45

  1. #1
    Tuner in Training
    Join Date
    Sep 2011
    Posts
    23

    Editing "I" and "L" settings - 4t45

    Anyone know how to do this? It feels like the pressure is based off the pressure tables but i have no idea how to do the shift points. I see D1 and D2 tables in the shift speed tab but it really doesnt correspond with what the car is actually doing.

  2. #2
    Tuner in Training
    Join Date
    Jan 2012
    Posts
    25
    is this for a cobalt because I am trying to learn the same thing

  3. #3
    Tuner
    Join Date
    Dec 2009
    Location
    Philadelphia, PA
    Posts
    64
    I've toyed with these setting a bit on mine. Nothing I seem to do really makes much of a difference. I have not spent too much time messing with it though. It seems to obey my set shift pressures and shift times I've set but it strays from my TCC duty cycles table when in "I" or "L"

    Take a look at the safety shift settings for D1,2, and 3. Thats what I was going to start messing with next.
    Last edited by viceroykarl; 05-05-2012 at 03:28 PM.
    2006 Cobalt SS LE5 | ZZP 2.5" Downpipe | ZZP Cams | HP Tuned

  4. #4
    Tuner in Training
    Join Date
    Sep 2011
    Posts
    23
    Same here on pressures and times. I wish i could make L gear not shift and just hold 1st.

  5. #5
    It stays there till REDLINE now, what more are you looking for by doing this ?