Logging AEM 5 bar for exhaust pressure

[Foose04]

This shouldn't be hard, but having trouble. I'd like to log exhaust pressure with this AEM 5v sensor (30-2131-75). I have the voltage table, but not sure on the next steps within EIO input.

In the scanner, i'm under...

Aux Input list, User Defined, Configure user defined, then what?

AEM Data on sensor: http://www.aemelectronics.com/files/info/30-2131-75.pdf

Thanks for any help guys.
-Rob Melcher

[Foose04]

Think I got it figured out. Would I be correct in going under "list", then entering the data -14.700 at .5, then 60.300 at 4.5. Then clean it up taking -14.700 down to .0 and 60.300 up to 5.0

[sarg]

I would think that entering in the exact voltage that the sensor calls for would be the best way. Other wise all readings will be off. Try it with the recommended setting and make sure it reads 0 or close to it with the car off.

[carlrx7]

(Volts/((volt range)/scale range)+(lower limit)

Using PSI
(Volts/((4.5-0.5)/(-14.7-60.3))+(-14.7)
(Volts/(4.0/75)+(-14.7)

Volts/
0.0533333333 + -14.7

Using KPA
0.0077556 + 0

-Carl