DBW pedal voltage adjustment?

[2001CamaroGuy]

Hey guys.

I'm starting an LS2/T56 swap into a BMW Z4 and would really like to reuse the BMW gas pedal (it is DBW). Is there a way to adjust the 0%-100% input voltage in HPTuners? I have never done DBW tuning before (had a 2001 Z28 with cable throttle) so I don't recall seeing a table.

Thanks,
Chris

[Shrek]

The BMW gas pedal won't work. You will need to match the APP (gas pedal) to the controller you are using. If this is an early LS2 with 24x CKP - then you will probably use a P59 controller - in this case you also require a matching TAC module. If this is a late LS2 with a 58x CKP - you can use an E38 or E67 - as long as the TB (throttle body) and APP are compatible with the controller OS.

[2001CamaroGuy]

Thanks. Guess I'll just convert to the older BMW cable drive pedal and use the F-body TB.

[DSteck]

You will have to use an LS1 PCM and not an E40.

[2001CamaroGuy]

Thanks, yeah I'll run just use the older F-body PCM as well. I was only looking at the Vette PCM/TB in order to reuse the BMW gas pedal. If I have to switch pedals I'm actually happier using the F-body PCM as I have unlimited licenses on it.