Results 1 to 3 of 3

Thread: Need help locating a table, e40 ecm

  1. #1
    Advanced Tuner angrygoat's Avatar
    Join Date
    Oct 2008
    Location
    New Baltimore, MI
    Posts
    358

    Need help locating a table, e40 ecm

    I thought at one time I saw a table that was an injector multiplier based on which cylinder number the injector was for. For instance, cylinders 1&2 were something like .94 and 7&8 were something like 1.03 and graduated inbetween the remaining cylinders. I can't seem to fin it and was starting to think I saw it while tuning another pcm platform.

    TIA
    Joe
    2006 M6 GTO
    APS TT
    10.76@131

    "The goal of tuning is for the tune to run well enough you dont need any corrective mechanisms"

  2. #2
    Advanced Tuner angrygoat's Avatar
    Join Date
    Oct 2008
    Location
    New Baltimore, MI
    Posts
    358
    Guess I'm finally loosing it
    Joe
    2006 M6 GTO
    APS TT
    10.76@131

    "The goal of tuning is for the tune to run well enough you dont need any corrective mechanisms"

  3. #3
    Are you referring to this, if so, I thought it was only E38, but could be wrong.

    http://www.hptuners.com/forum/showthread.php?t=37220