Methanol pressure sensor slope configuration help pls

[U Tried]

Guys and gals i have a 5v pressure sensor that should read .5 volts at 0 pressure and at 4.5 volts it should read 150 and 150 is max.... Ive tried to configure it with a little sucess but im getting 18 psi at idle pretty much with the way i had it configured... Any help would be appreciated thanks in advance!

[Alvin]

Try using my little spread sheet. It was meant for wide bands but I use it regularly to calibrate map sensors and fuel pressure/oil pressure sending units.

http://pcmforless.com/index.php?opti...ning&Itemid=56

[U Tried]

Try using my little spread sheet. It was meant for wide bands but I use it regularly to calibrate map sensors and fuel pressure/oil pressure sending units.

http://pcmforless.com/index.php?opti...ning&Itemid=56

Awesome Alvin ill test it out today! Thanks for the help and quick response

[U Tried]

Ok this is what i got from my data but im getting a -2.0 pressure reading when no pressure is on it, what data should i plug in hp tuners and where so i make sure im headed in the right direction

[U Tried]

Ok i belive i got it Alvin lol i forgot to put 145 for highest psi, now it reads withing .50 psi of 0.... Btw great job on that spread sheet thanks for taking the time to make it!! It sure will save me alot of time now

[Alvin]

No problem!