finally got my HPT working. after several trys to get it working on my newer Win7 64bit laptop, unsucsessfuly, i resorted to pulling my old laptop out. its got a bad harddrive or something and was only able to get into WinVista thru SafeMode. but, thankfully, HPT works under SafeMode and is able to hook upto and read/scan the car and truck. so i went in and played with some settings to try and remove TqM. i have a copy of the stock tune if i need to go backwards. heres what i did, (if i missed or did wrongly, plz chime in)
engine
- TqM
****SparkRetard vrs Tq Reduction
~~~~~ set whole table to zero
****ETC Limits
~~~~~ set whole table to 100%
****TCS Enable ECT
~~~~~ set to max of 493F
****Max Tq Brake TqM (Brake Tq limit)
~~~~~ left at preset max of 6042ft lb
i also set my tire size to 31" tires with it set to "Auto Scale Trans Table - YES"
now, there is also a spot for TgM under transmission, but it talks about Tq Reduction and Duration during Trans Abuse Mode. and Tq Reduction during normal/performance and downshifting. and "diff score Tq reduction master enable" which was set defult to "disable". nothing under this was changed.
now, the test results...
loaded the new tune, and started the truck with no problem. drove the truck the to the end of our development and down the start of a sand trail. attempted to powerbrake the truck, and was able to get the tires spinning, but only to a limit of about 2500rpm. once i got the truck back on pavement, and tryed again, truck went to 2500rpm, but wasnt able to break the tires loose.
did i miss something? even tho i've had HTP for a long time, still new to tuning.